Which router bit?

[Essex Barn Workshop]

I recently bought, from this forum, a Trend Routasketch and so far, so good. It's fun to use and works well.

I don't have any experience of routing signs or pictures etc, and am using a 1/4" router in it. I'm now keen to make some signs with images etc.
I'm after suggestions for a bit under £20-25 for line drawing with it please. I may go on to buy more expensive bits, but for now I am still practising.
This was my first attempt with it, I've sprayed the image in a grey primer (it was to hand!) to highlight the image.
Thanks.

 

[Phil Pascoe]

A bit over budget, but you won't buy another one. Engraving 90 Degree

also in 60 degree.

 

[Droogs]

for the above, Though I would go for the 60 degree bit.

 

[Essex Barn Workshop]

Thank you both, I have now ordered a 60% as suggested so thread closed.

 

[Phil Pascoe]

What??? You're not going to tell us how you get on with it?

 

[Essex Barn Workshop]

Ok, I’ll add some pictures as and when!