Tool for awkward nut (not me)

[mc281]

Can we please not ressurect old threads where there is nothing to be gained and or the op may no longer be a participating UKW member. It is much better to start your own thread which will get more attention than something from the past.

Maybe close the thread after you've had enough responses. I'm sure this system allows that.
I 've thrown myself off a bridge already.... Luckily I was saved by my thick skull

 

[Noel]

Maybe close the thread after you've had enough responses. I'm sure this system allows that.
I 've thrown myself off a bridge already.... Luckily I was saved by my thick skull

That makes no sense. These are discussion boards, not a Q & A session.
Before this thread is locked how did you manage to land on this thread?
Thanks.

 

[mc281]

That makes no sense. These are discussion boards, not a Q & A session.
Before this thread is locked how did you manage to land on this thread?
Thanks.

I searched the forums for 3D prints, saw a question, didn't read the date and responded with what I hoped with useful advice.
I was rather surprised at your abrupt put down, hence my bridge comment.

 

[Noel]

I searched the forums for 3D prints, saw a question, didn't read the date and responded with what I hoped with useful advice.
I was rather surprised at your abrupt put down, hence my bridge comment.

Thanks for your reply. Your bridge comment was made before I posted.
Anyway, be careful on your next crossing…..