thicknesser blade set up bdh2000-330 charnwood w575 + others

[proview]

hi all
help and or advice please
I have an old thicknesser a Berlan BDH2000-330 maybe German as it says Dickenhobel on it I am changing the blades but do not have the mounting jig are there any initial set up numbers or does any one know the correct settings. I think the machine was sold under many badges but after searching high and low on the web I have drawn a blank

cheers
stewart

 

[MikeJhn]

Start off with the blades set level with the outfeed table and see how you get on, that is how I run mine, lots of people do it differently, but that is how it works for me, I use a piece of plate glass to set them.

Mike

 

[proview]

Start off with the blades set level with the outfeed table and see how you get on, that is how I run mine, lots of people do it differently, but that is how it works for me, I use a piece of plate glass to set them.

Mike

thanks for prompt reply well that will give me a starting setup maybe a running setup (hopefully)

just found a manual to Perform CC10T Thicknesser that looks exactly the same model
cheers