Steel Conduit, Off-Cut for Veneer Punch?

custard · 22 Dec 2020

I make most of my veneer punches from steel conduit. I've just split my most used punch, but I'll have to buy a 3m length of conduit to replace it. Has anyone got a 150-250mm off-cut of a 20-30mm diameter galvanised steel or stainless steel conduit?

I'll of course pay postage, or I'll swap you for an off-cut of a highly figured timber. Your choice from say Fiddleback Maple, Tiger Oak, Curly Cherry, Rippled Walnut, Rippled Swiss Pear, or Rippled Sycamore.

billw · 22 Dec 2020

If you need a customer for some of those offcuts..... *looks in wallet*

AJB Temple · 22 Dec 2020

I've got plenty of galvanised conduit and can cut you a length off. Just tell me the exact length you would prefer. I can cut more than one piece. Can you remind me of your address please by PM. I know I have it somewhere but PM will be quicker. I can get it in the post tomorrow but Christmas post is going to be iffy. Kind regards, Adrian

AJB Temple · 22 Dec 2020

PS, I am presuming you don't need threads on one end. If you do, let me know and I can do that as well.

custard · 22 Dec 2020

AJB Temple said:
PS, I am presuming you don't need threads on one end. If you do, let me know and I can do that as well.

You're a Christmas hero!

Absolutely no rush as this job can easily wait until January. About 200mm long, no thread. PM with address sent.

Huge thanks!