Naerok mill - cutting out

[Housey210]

can not see any face fixing screws to dol buttons. Is that a toggle clamp hanging down, and does that hold the buttons in place?

 

[biker_smith]

Hi all again - so I never found any issues with all the above checks - but still have the cutting out issue. I've not really progressed as I've used the machine very little this year. However had a go today at a small job and surprise, still have the issue.
If I want to at least eliminate the DOL and replace the box - can anyone suggest which one I should buy of eBay or whatever?
Thanks again - Paul.

 

[guineafowl21]

https://inverterdrive.com/group/DOL-Starters-Single-Phase/WEG-DLWM-075-Direct-On-Line-Starter/
I would suggest you measure the current drawn during milling before replacing the starter.

 

[biker_smith]

Happyness is a working Mill - special thanks to guineafowl21

Best regards - Paul.