Ironballs
Established Member
I have a couple of things for sale following recent purchases/upgrades.
First is a No 5 plane by Groz, it's the one sold through Axminster. Great plane that's a good workhorse, nicely fettled and hasn't had vast amounts of use as I've only had it about 2 years. These don't cost a huge amount new so will accept any fair offer plus postage - which I haven't worked out yet, but I guess is going to be about 7 quid.
The other is a boxed set of 1/4" shank router bits. Recently bought a load of routing gear on ebay and this set was in there, I already have these bits in another set so are surplus to requirements. They're used but seem to be in good condition and sharp, though the 1/4" radius corner rounding bit has an upper corner knocked off, however, this part of the blade is not used when routing that profile so shouldn't be a problem.
They're from Axminster and I think are an early version of the Perform range of bits. Again will accept any fair offer plus postage
Not yet extracted from the garage and taken photos, but I will also be selling my Trend Craftsman router table and an Axminster block plane. If you're interested in either of these then PM me for more details and photos and I'll get my ass in gear, otherwise they'll follow on here in the next week
Cheers
Damian
First is a No 5 plane by Groz, it's the one sold through Axminster. Great plane that's a good workhorse, nicely fettled and hasn't had vast amounts of use as I've only had it about 2 years. These don't cost a huge amount new so will accept any fair offer plus postage - which I haven't worked out yet, but I guess is going to be about 7 quid.
The other is a boxed set of 1/4" shank router bits. Recently bought a load of routing gear on ebay and this set was in there, I already have these bits in another set so are surplus to requirements. They're used but seem to be in good condition and sharp, though the 1/4" radius corner rounding bit has an upper corner knocked off, however, this part of the blade is not used when routing that profile so shouldn't be a problem.
They're from Axminster and I think are an early version of the Perform range of bits. Again will accept any fair offer plus postage
Not yet extracted from the garage and taken photos, but I will also be selling my Trend Craftsman router table and an Axminster block plane. If you're interested in either of these then PM me for more details and photos and I'll get my ass in gear, otherwise they'll follow on here in the next week
Cheers
Damian
