Reply to thread

Hi Chipp,

I recently completed my own face frame kitchen for our new house. This is the link to the orignal thread. Unfortunately as we're fairly rural now, at the moment I can't get broadband to post the completed pictures. Anyway I started off trying to use a beading bit too but I found the level of accuracy required on every single piece of face frame just too time consuming. In the end I machined the beading and attached it after. It worked out great.

I presume you mean the Kreg pocket hole system. I used this and found it to be great. Not one joint opened up. One tip on any pocket hole system though is when screwing the face frame together clamp the joint because when it pulls together it will tighten too much and create a slight step. I use one of these. Hope I explained that right.

Best of luck with it.

Neil