Door locks not sitting back in mechanism

[Aussie in Wiltshire]

Ok
Strange one but I am sure I am just being stupid.
I have just hung a brand new door Inc frame and architrave etc to ensuite.

Have just gone to put the new lock on and it doesn't sit back in the mechanism properly. Just checked the other new one and that is the same.

Is there an adjustment on them?
What am I missing.
Others on new doors downstairs all finish flush

 

[Diver Fred]

Face plates. Can you post an image face on please.
And make name.

 

[Bingy man]

Evening - what type of door wooden or upvc ? Are these 2 latches identical or is one new and 1 old ? I’ve not seen those cranked face plates on traditional wooden doors .

 

[Aussie in Wiltshire]

Both brand new from Howdens
I'm going to take one off downstairs which someone else fitted last year.
I'm wondering if there is a face plate and I just need to set them in deeper in the door

 

[Aussie in Wiltshire]

Sussed it there is a plate that goes over it
Always good to think it through
That's the trouble when you are just picking up after someone else and sifting through a box

Thanks everyone

 

[ChaiLatte]

Sussed it there is a plate that goes over it...

Normally they are supplied with two face plates, one in silver one in brass. The extra over cost of production is less than having to keep two stock lines.

 

[Katomi woodsmith]

Good that you sussed it. I find that if I get a prob like that, I go away and come back to the task later.
Today is an example, I was turning a project, I cracked the piece… so I cleaned up and went for a coffee sitting dunking a bikky I realised what did wrong
So in the am I will have another go