Reply to thread

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Did those folks send these to you since you acquired that microscope by chance?


Not intending to make a wide burnisher anytime soon, as I have a Crown one also, bought near 10 year ago, and it seems to me from your vid on the subject ,

that the buffer is much superior than anything else I've seen.

Not going to run out and buy another grinder or anything, as my methods work well enough for me to get by.


Not noticed the lower part being soft and getting scratched, but admittedly don't use a scraper often.


Used a drill bit a few times for the job, rolls a burr on some old hardpoint saw plate, as well as it does on my Bahco scrapers, not ever tried anything else.


What a variance of burnishers there is, with some like Pete making ones from something like 5mm drills (I think?)

Interesting that I've never seen a close to moderated discussion on the topic,

Does that say anything?


Back
Top