Reply to thread

DemiFrog,

Yep, I did buy it but haven't had gotten around to using it yet  .  It was one of those wonderful impulse buys (which was given a helping hand by the £99 pound offer NMA had on at the time).  I'm in the middle of yet another workshop re-organisation at the moment, but hopefully after that I'll get the opportunity to do some "real work" and give it a try.

I just took a snap in the workshop - first attempt at posting an image on this forum, but here goes....

Basically you get two beefy cutter blocks, with 2 cutters each, plus some shims to adjust the spacing.

As for protection - that's something I'm still mulling over (and part of the reason I haven't used it yet).  The over-table guards from Axminster (+ Suva guard from Scheppach) are too damn expensive, and I don't really have the room for yet more kit.  I'll probably go along a similar route to Philly, and construct something that attaches to the rip fence.

Martin.

P.S.  Philly - apologies for the minor hijack of your thread...