bevel cutting

[cowboy682]

Morning all
l understand bevel cutting so the piece your cutting drops down into the wood, but what do you have to do to make your cut stand proud of the piece your cutting?
Thanks Graham

 

[Bryan Bennett]

Hi Graham I have cut out a couple of patterns that have requested that you tilt the table at 5 degrees,and insist that you cut it out in a CLOCKWISE DIRECTION.if you do so it will drop down slightly to make a frame.
I am almost certain that if you cut out in a ANTICLOCKWISE DIRECTION the reverse will happen,I think I did it once.I would suggest that you try and cut it out on a scrap piece of wood.

Bryan

 

[cowboy682]

Thanks Bryan
that is what l was thinking
Graham