Are you going to Axminster soon? Can you do me a favour?

[The Bear]

Hi

I need to get a cheap router bit from axminster for a project I'm doing. Trouble is I live no where near a store, the bit is less than £10 and I don't need anything else. Needless to say I don't want to spend £5 on P+P.
If I sent the cash and a bit for an envelope and stamp would anyone be willing to pick it up and put it in the normal post for me? No liability on your part, if its lost in post, that's life, my risk.
This is it
http://www.axminster.co.uk/axcaliber-fl ... -1-4(635mm)-prod805335/
Need 12.7mm diameter, 19mm depth of cut, 1/4 inch shank. £8.10.
Can anyone help me please?

Mark

 

[jasonB]

Would almost be as cheap to get it from Wealden, £8.94 & £1.50 must work out about the same as you posting the envelope and the cost of the small packet back to you and more than liekly a better quality cutter

Jason

 

[The Bear]

Jason

Thanks for that, I had looked at Wealden and could only see the Template Profilers which are expensive. I've looked again and found the trimmers though the cheapest 12.7mm diameter one I can see is £12.10. (I don't actually mind paying a bit more for a better quality bit, its the excessive axminster postage i object to).

However for the life of me I still can't see the bit for £8.94, could you post the link please?

Thanks

Mark

 

[jimi43]

Hi Mark

Link did not work...can you post a pic and further info on the type you want...

I may have a spare which you can have gratis

Jim

 

[MickCheese]

Try this

http://www.axminster.co.uk/axcaliber-flush-trim-cutters-top-bearing--1-4(635mm)-prod805335/

Mick

 

[jimi43]

AH....bottom bearing...don't think I have one of those...

Will check the workshop in the morning and let you know

Jim

 

[The Bear]

Mick

Thanks, thats the one, bearing at the top, I didn't realise the link was not working

Jim

Thats very generous and appreciated


Mark