Reply to thread

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  • If you have bought, sold or gained information from our Classifieds, please donate to UK Workshop and give back.

    You can become a Supporting Member or just click here to donate.

Update, well it seems the early GHA tool and cutter grinder does not accept 20mm U2 collets they are 16mm dia.  So it is looking like I may have to make them, or at least adapt an ER collet holder as I need a half inch (12.7mm) collet) and currently only have 1/8" and 1/4".

er16 only goes up to 9mm, so need an er20 with a 16mm straight shaft. I will have to see what I can find, heads are available, though I may just make a single 1/2" collet and be done with it.


Back
Top