Search results

Hi The 125mA fuse is the recommended fuse for the counter, the sensors run on 24vdc supplied by the counter, the transformer is fused separately to the counter at 2Amps with no earth, only the motor has an earth wire the transformer and the counter have no earth connection - the incoming earth...

Hi Thanks for your reply I'm more inclined to suspect the transformer than the sensors or the counter as that's the oldest component, the counter and sensors are both new

Hi folks I wonder if any one can help me I have a machine with a 3 phase motor that also has a transformer converting 230vac to 24Vac to power a start stop contact switch, the machine also has a digital counter that runs on 230vac and gives out 24vdc to power a couple of sensors, both the...

Ok Thanks I'll need to bring the motor home again from work So it might be a day or too before I get back I only have a cheap multimeter But I do have a Fluke Multi tester - am I ok using the resistance settings on this machine instead Thanks for your help

Hi Thanks Just run through what I need to do to test with my multimeter

Yes it's on

Hi Thanks I was thinking that the red wires were one for each winding and the black a common for both but I don't really know There's no continuity between the two red wires so if they are the main winding then it's probably popped as you say But if that's the case then what is the back wire...

I know it's not in the best of condition but I like a challenge, it's been stood for about a year and was covered in a combination of over spray and saw dust but it turns ok

Here are a few photos

Hi Thanks Was without my phone yesterday so didn't see all your replies This is a bit of a project, the compressor is at work so I've not got it with me but I've got some photos on my phone I can try upload I've never seen it work and I don't trust that it's wired correctly either, I just...

Hi Newbie question I have a single phase Clark Raider compressor that won't start - I have replaced the capacitors and connected them as per the old ones but still no joy I'm suspecting that the motor is toast I'm a bit confused by the wiring though The motor has 2 red wires 1 black wire and 2...