Search results

Hi All, Just wanted to say thanks as finally got my planer back up and running following all the suggestions and advice on this forum.

Thanks, it was an old link I tried but this has opened fine thanks again. Steve

Thanks , have tried to open a previous link to the motor paper and it will not open . I would be grateful if you can forward it to me. Kind regards Steve

Hi Myfordman, I have recieved the switch from the supplier and my sparks came over to fit this for me but the supplied wiring diagram did not make sense, would you have a wiring diagram that you have used for your previous machine that you used? I am grateful for any help you or others can give...

I am somewhat like you, in as much all of my tools get a thougher going over and if I am honest a lot of my tools tend to be used once in the year as I have favourites I like to use more than the rest. I good tip thanks clogs. A lot of the machine tools I have , have been in storage for a number...

Now ordered delivery due end of next week.

Thank you.

As I have already said I know nothing on electrics having trained as a cabinet maker and retiring as a senior construction manager having built everything from hospitals ,civils, banks ,police stations etc which I could go on and on in the places I have worked along with countries I have worked...

Sorry but I know nothing about this type of electrics

Thank you for this much appreciated, as my machine is single phase what range of overload would you recommend as it currently comes up with 9 to 13amp overload is this fine or do I go with a higher rating? Regards Steve

I would agree but as I am not an electrician I have to go by what was found. I am told by dave at DB Keighley, as I viewed a different post that these switches are no longer available due to the age of the machine. So unless some one can point me in the direction of where I can get one then I...

Having spent a good couple of hours with an electrician friend last night looking at this it would appear that the switch has had it due to corrosion and is not repairable. So I am going to try and find a replacement switch but I think it is unlikely due to the age of the machine that I am...

Thanks for the reply, Just as a thought if I cannot get this going and decide what to replace it with what would you recommend? Of the same or similar spec.

Thank you, Knives are brand new and currently barely skimming the wood which is why I am confused as to what would cause it. I would not know how to adjust the DOL starter, is this something that the manual would cover or could this be a job for a electrician? I did wonder if it could have been...

Hi All, I have been given a Kity 636 planer which has been in storage for a good number of years. I am having a problem with it switching it self off when starting to plane a piece of timber, when not planing it happily works fine and does not switch itself off. Could this be down to the switch...