Search results

This is an Axminster Tool Centre model which I have had from new. User manual is included. All parts work well except for the laser which failed a few years ago and I never tried to replace it. Max crosscut at 0 degrees is 90 by 300 mm. Mitre angle range is 45 - 0 - 45 degrees. Weight...

Thank you for the comments. The belt I am using is on that came with the machine, which has the facility to rotate the belt forwards or backwards. Even when using the smallest amount of pressure on the chisel against the rotating belt, there is a noticeable bang on the belt, which is felt...

Have recently purchased an Ultimate Edge Sharpener and have just been setting it up. Having now completed the set up, I have found the belts are very noisy with the slightest amount of pressure from the chisel being sharpened. This means the chisel vibrates. It sounds as if the join in the...

Now sold.

Yes, it is still for sale.

Not yet sold.

This system is designed for the sharpening of all woodturning tools with one jig. Contains: Instruction Booklet Single base slide 3 screws to fix base Toolholder Short steel rod. Also included are a) 3 'home made' guides to...

Contains: Original Box User Guide Standard clamping head Narrow clamping head Straight roller base Camber roller base Angle register jig More details can be found...

A big thank you to those who stayed up late last night to help me with my mm. I'll try again with a bigger effort to get my measurements correct. Would I be better getting dogs with 19.95 mm diam or 19.90 mm diam to fit a 20 mm hole in a bench top?

I"ve just started making my own bench top with this system, but I haven't yet bought any dogs. I was wondering if anyone has used the sets of 6 dogs being sold on ebay, which are 1.95 mm in diameter. If so how well do they fit in the 20 mm hole? There are some reviews saying they fit well in...

I've had a Record BS350 for over 2 years. It's a pleasure to use.

When you say 'open circuit coil', can it be fixed? Does it mean there is a wire disconnected some where, and ail it be obvious?

My NVR switch on my router table has suddenly decided to fail to remain in the ‘on’ position. If I press on the switch, power gets to the router. As soon as I release the pressure, the router grinds to a halt. Can anyone please help with a remedy? Is it likely to do with dust entering the...

Thank you for all the help. I've sent off an order to Amazon.

It's blade number one with eleven notches. I can't move it down a notch as the oval slot in the middle of the blade rests against the disc on the top of the lateral adjustment lever. However, as my blade is only just over 4 inches, Vann's measurement of 4 3/4 inch highlights my problem. So it...

I can't get he blade on my Record 09 1/2 block plane to stick out far enough to contact the timber. This is the Record model with the horizontal brass adjustment wheel, unlike the newer version with the vertical wheel. At the top of the travel of the wheel, the edge of the blade is just...

Thank you for all those helpful comments. They are certainly food for thought.

I certainly would want a good quality variable speed, but how would I identify an 'industrial strength' type? Would you expect the Jet to have an industrial strength version, but not the Warco, bearing in mind the price difference? I understand the Jet is manufactured in Taiwan and the Warco is...

i’ve just been comparing these 2 lathes on paper. At the moment the Jet is £740 more then the Warco. However, looking carefully at the published specifications, the only differences seem to be that the Jet is 24 Kg heavier and 236 mm longer. They both have swivelling headstocks, both have 42...