Search results

Forgot to thank Bob for the manual its very informative I have a bit of paperwork & a book for the Kity

Hiya! don't know how the pics doubled up but at least it worked you can see the problem I had on the planer tables but I think I've corrected them & no snipe!! I just have to run some stock through the thicknesser to see if its planing square! I will try the spindle moulder with the slot cutter...

Hiya No sure if these pictures will work hope hey do!

Hi So on testing the planer I found the blades were too low in the cutter block I removed the blades cleaned & lubricated the assembly then re set the blades I used a piece of paper on the out feed table with a steel rule pressing down It took about 3 attempts but managed to reset & test the...

Axminster tools have £100 off Veritas planes

Hi Rodders Have tried without success to post photos will try again later in the meantime I've discovered that the French are strange race everybody else ( I think) adjust the infeed table to the out feed table but the fiends ( French ) do it the other way round There are four bolts on the...

Hi all The planer / thicknesser has an outfeed table square to the blade The infeed table is square to the blade at its maximum height but if you lay a straight edge to the out feed table It's all in line but the end of the infeed table drops down away from the straight edge by about 1/4 inch...

Hi redders I assume you agree that the tables are fixed so no adjustment it does not affect the planer use but I will work on it & let you know if I find a way My moulder has a 15mm split spindle I have a slot/ rebate cutter not sure if I will use the latter But as you say it's great for...

Hi Rodders Thanks for getting back to me! I will look for the date plate next week,mine is a pretty old model but in good working order just needs a bit of TLC. I thought the bolts you mentioned might be adjustable but there does not seem to be a groove or a slot in the framework which would...

Not had any response from this question thought I would try again Can you adjust the infeed table? ie: make it level with the outfeed table mine drops away towards the adjuster by about 5 mm Thanks!

Hi I have acquired an old Kity 5 it's in a nice condition but requires a bit I of adjustment to work correctly The planer out feed table is level and square to the blades but the infeed table drops away by 5 mm is there any adjustment on this to bring the table level with the out feed? The...