Search results

Hi, What bandsaw blade should I use for cutting curves in wood?

Best snd simple waybto fill in part of window reveal,as on photo,theres some foam in there,about 2" deep!

Have leak in velux window,flashing was changed 6 yrs ago! Stain inside right hand lower corner,butdry on outsideof that point,no rotting outside either,windows over 10 yrs old! Leak is higher above where stain is! Velux say,from photos given,that they can't see a problem,but the screws may be...

Anyone know where I'd get one these?,I know it oldish,has to be like this,though!

How can I get rid of a slight bow in a length of wood to be used for a door,I don't need to plane or reduce it's thickness!

Anyone got a way,a simple one,to cut a 25° bevel or chamfer edge along the length on a 4x1" piece of wood? It's for either side of a ridge bord for a green house!!

Have the above, can it be attached to titan mitre stand? Specifically,due to these holes they're 10mm,but,when bolt is put through,there a gap between the saw base and the clamp! Would I need anything between them?

got a used one of these,does anyone know where I could get a plastic insert for the mounting bracket,this is the square hole the workstop goes into!

Anyone know or seen what these mitre saws are like?

Have new blade,but,getting blade drift,so,I adjusted have the fence at an angle, which corrects the drift! As I don't want to leave the fence at an angle,do I twist the table in the same direction as the fence,and then straighten the fence?

Have drill.press,but the drill bit wobbles quite a bit,can it be fixed?

Have a basa3 bandsaw,and changed blade to 16mmx.55mm is the tension for that blade the same as smaller type blade? This blade is difficult to position on wheel as it is same width as wheels on bandsaw!

Any advice on how to install a splashback,have tried tech 7 but didn't work! Would screwing it in be be better?

Hi, Who should I ask about safety grab rails for inside attic,it may need to be customised?

Has anyone got a gas cooker,that when reaching correct temperature,the oven burner automatically goes out,and then comes on again when temperature falls? I know it's not a fault with the appliance, I just never heard of them before,nd wondered how ppl found them? My present gas cooker doesn't...

Hi, Anyone know the differences between Dremel 4000 and Dremel 4250? I know there are different kits,I'm just interested in the machine itself

Hi,I know this is off topic,but,does anyone know a way to stop a washing machine moving during the start of a full spin cycle,it's standing on a subfloor,or floating floor?

Anyone have one of these,it's set up but when running, the drill bit wanders while turning! Any thoughts?

Anyone know what type bolt these are,they're from a featherboard kit,and they're too big for the milled recesses in my Basa 3 bandsaw?

Hi,Is there a featherboard kit one can buy for the basa 3 bandsaw,I notice the channel in the table for the mitre jig is a bit narrower than other bandsaws!