Search results

I have only just seen that Cascamite has a new manufacturer. Has anyone used the new product? Problems eliminated? I have been using Semforite but I can't get used to the grainy texture.

A friend has a conservatory that was completely restored a couple of years ago. Same glass and strangely, they posted only a couple of days ago, just like OP. Rokeby Hall In an earlier post, 2nd June, You will see a lean-to glasshouse. The glasshouse was built before the conservatory restoration...

I found the Scheppach Basa 1 to be quite good, and easy enough to move, I had it in a corner when not in use. It should be readily available in Ireland but it is small. Much better than the Parkside. There are probably larger Scheppach models that would fall within your budget. I got mine at...

I disconnect fridges and freezers during a low voltage period. I believe the lower voltage means higher current which can damage the mtor/pumps.

Did you install the Creality Ender 3 v2 dual z axis upgrade or another make? Is there a better option?

I have a very long narrow house with 600+mm walls. I put in cat 6 and have 3 wap with poe. Bear in mind with waps you cannot start a call at one end of the house and walk the entire lenght seemlessly. If the walls are thick there is significant loss of signal even from one room to another. I...

Sorry, I didn't remember you had the S1 pro with self levelling.

What do you mean by auto levelled? That you added something like a BL touch?

And what about levelling the bed? I seemed to be forever, every print, checking the bed.

So how much roughly did it cost you in upgrades to get it working in a reliable way?

I have read that you can damage the bath if the parts are in direct contact with the tank and not in a basket.

This might help. Spax

I'm afraid he wasn't too bothered and buying a new blade from Tuffsaws here in Italy means 2 lots of postage and two lots of VAT so it never happened. What I found when trying to get the blade centred on the top wheel and under tension was that it would either pop to the back or pop to the front...

wish I was in Uk

Although he has used it to cut stuff rather badly for some time, including nails. I would start by buying a decent blade from Ian at Tuffsaws.

I tried quite hard to set up a ferrex saw for a neighbour, with the original blade and without success. No matter what I did I could not get the blade to track in the centre of the wheel. His saw does exactly the same thing.

No problem

The sizes and pitches are all listed. 3/16", 1/4" and 1/2". I f you were interested I'd check the invoices from Tuffsaws to make sure.

Good wide choice here and mostly quality kit

You never posted any more goodies.