Search results

Does it come with its own dimension as the 3 I have in the shop are all full up? :whistle:

Now I think that it would have looked better if you had just purple heart as the contrasting wood, maybe you could try it on one of the current production?

You where lucky! I bought some kits via ebay from him, total value AUS $40, I had to pay £2.98 VAT, along with an £8 handling fee from the Royal Mail. #-o Good kits, but I am not sure I will order from Aus again. :-k

Good progress, keep them coming. :D

Sorry Chas, I have not made myself clear, your table is the on line version of the Zeus page, very useful. 8)

I don't know what it is about this one but I really like the look of it, :D looking forward to how you make the top. :-k

That table is an on line Zeus page, thanks Chas. :D

Nicely done. It would fit in at my folks place, they have lots of 70's teak furniture.

Hi, f you want to practise turning on the mandrel, you need to drill a hole that matches the diameter of the mandrel, not the brass tube. You can buy a pen dissembler that will allow you to get the thing apart again, its on my list of things to buy. I sand my pens with 120, 180, 240, 360, 600...

I am well down The Slope TM compared to you Roy, this is my fourth set. :roll:

I have moved lots of heavy and large stuff on sets of these, the only thing you need is a smooth floor. They are very small wheels so don't like lumps or holes in the surface.

Well I think it is a waste on bunny's, it would make a nice workshop. 8) :wink:

Nev, The problem you will have with any new motor will be the size of the shaft, the old motor will only have a 1/2" or 5/8" and a new motor will be 19mm at least. I had this with my motor swap and had the pulley bored out. There are some good ones on ebay at the moment.

Now that sounds like a good solution, a Graduate with full speed control. :D

I would like to know as well, I have use BLO on oak, with no obvious bad side effects. :-s

Many you just need to wait around bit................... Hat, Coat, Door.........

Depends on the type of ceramic, I used some, many years ago in thick film hybrid prototyping that you had to warm before you could solder a joint on as it conducted heat so well the iron went cold as you applied it. :shock: Am I correct in thinking these blocks are used to hold the cast iron...

We lived in a bungalow when Joe was small, I got a stair gate to keep him in his bedroom, when required. Seemed like a good idea. I had to do the pressure pads up so tight that the then SWMBO could not undo them, any looser and Joe just undid the gate and moved it out of the way. :roll: He did...

I stumbled across this Auto Feed Pellet Burner in the Axminster catalogue; Fits a number of their Rojek Wood burning boilers, any use?

George, You had lost the end of the URL, I have added it and your link should now work for everyone.