Search results

Thanks for all your help I'll measure it tomorrow and if it's far enough on I'll leave it as it is Once again Thanks it says you have been thanked 51 times make that 52 if I knew how to register a thank you I would Cliff

I have had the centre ejector on but the chuck only screws on about half way it feels tight but being new to wood turning i was a bit worried that it might need to go on further to be safe thanks for your trouble like the photo by the way I was trying to work out how to put one on now I don't...

the indexing pin locks the spindle pulley and sits at the side of the drive spur but it is about 5mm to near to the drive pulley to allow the G3 Chuck to screw right down on the head stock I have never used it and thought if I removed it. would be better than fixing a sleeve to stand the chuck...

I have an oldish Draper wtl12 lathe and have just purchased a nova G3 chuck only to find that it will not screw on all the way due to it catching the indexing pin. Is it a hard job to remove the indexing pin it doesn't look to bad but not being engineer minded I would like some advice before I...