Search results

Ah ha! Thanks very much! I see I twisted the belt the other way… also the belt runs truer as before it fell off towards the Motor side during start up occasionally. I can now put all my guides on the correct way and probably have to turn my cutter block the right way up :-) Yes I find the...

Thanks for all the advice I put a sacrificial fence there now and break through much more stable. Does anyone have this machine and can advise on the position of the spindle moulder belt, I’ve notice mine runs clockwise and does work better if I feed in from left to right, where as the diagram...

I have a user manual but it’s quite basic and I’ve watched the video thanks very much I’ll make a fence each time it seems to be the way to go it produced a much better finish that my 1/4 inch router

Thanks guys, I just get a slight wobble when coming off the first fence at the end of the cut I’m using the spring guards, it has a sliding attachment for this too but it has a 90 degree fence which wasn’t suitable for the long lengths. I might just make a sacrificial fence.

It looks original and comes in the parts catalogue perhaps I’m not describing it well, luckily I have the spindle block and quite a few profiles, I’m just used to having the bearing on a router and struggle at the end of the cut

I have an old Kity k5 and have herb using the table saw with sliding sleigh which is really effective. I have the spindle moulder attachment with the euro block and some bits, I’m used to using router bits with bearings is it possible to fit normal router bits? Any advice would be appreciated...