Search results

Thank you for replying, as ever i'm overthinking it. If i've got the material and it looks right, it'll be fine. Thanks both.

Hello All, Is there guidance or Golden Rule regarding Rail and Stile ratios/widths? Some internal cupboard shaker style doors along a wall each 'gap' is aprox 1000mmx1050mm so 500/1050 doors (plus overlap). Will likely go for an intermediate/middle Rail. First foray into shaker doors and i'm...

Hi all, I’ve an MFT for panels but looking for table saw to go with it, general home/hobby use. Budget around £500 which would get me a startrite or Sip 01332 which would replace a dewalt site saw, so either one an upgrade. Any thoughts on which way to go? some great startrite rebuilds on here...

It does, but not with that 'third' bank of hotels in the middle leaf - That's why i wandered if their was a special name for that style.

Yes, searched for storm and cranked, but only found them with single set of holes on each ‘butt’ and none in the middle section. Guess I can just drill and countersink them. Thanks for ideas all.

Hi All, Any idea what sort/name of this hinge is? Thanks all.

I’ve a Kreg plate I didn’t end up using, I’ll pop it in the for sale section. It’s for the tra001, so not sure about the MF.

So early forties for me, my trigger is beige/heavily processed food, so probably a good thing I try and control it. Strangely I also think diet free drinks and Weiss beer can cause an episode but may just be coincidental. If I get a twinge i’ll take a naproxen as soon as I can and that way I’ll...

A5 Black book and pencil For me - that way I can very quickly flick back and see how designs progress. Ie rough out sketch with rough sizes through to finish sketch with accurate dimensions and cutting list with bill of materials. Back of book for all working out/rough stuff and when...

All, Met Mark earlier today to pick the stuff i'd bought from him, all exactly as described. If anyone is on the fence about some of the stuff he's selling, all i can say is that it's all in great condition, thoroughly looked after and in a very tidy/well maintained workshop. And on top of...

hello all, building mitre saw workbench from some old kitchen cabinets, a run of three units with the mitre saw between two of them so it’s surface is flush with the workbench top. The bench ‘worktop’ will be plywood bonded to Mdf, both 18mm. To give me a clean edge I plan to finish it with a...

Sent you a PM Mark

Hello Chiippyjoe, interested in the ctl26 and the 9403 if you have a price in mind for the two of them?

All very helpful, thank you.

I’d be treating any end grain. Plates makes sense, ill be using joist hangars so I’ll add them to the shopping list. Thank you.

Hello all, building base for a cabin to sit on. I’ll be laminating 2x4’s, but wondering best way to ‘butt’ joint at the corners? Picture below from tinterweb where I’m guessing they’ve nailed through. The base will be sat flat on a series of paving stones. Thanks for help.

Same here, cutting lube for metal but not for wood. Wax/paraffin on the beds but not much else.

For bandsaw/tablesaw use lots of ytubers seem to be using an aerosol cutting spray? Is this just a PTFE type spray and if so does it not mess with the tyres on a bandsaw? Would it not also collect up the ‘gunk’ and turn into an abrasive compound? Asking for woodwork not metal work. Thanks all.

Gosh no Padster, good you took the time to respond, appreciate that, sometimes I have been guilty of looking in the obvious places.

The sticky is handy Padster, but nothing local for Lincoln, hence asking the question.