Search results

@ChaiLatte thanks for that solution, I didn’t want to initially go with the measurement of the one that came off as I wasn’t sure how much it had stretched over the years. If I’m measuring to order is there any merit in measuring between the pulleys with string rather than around the belts?

Good afternoon all After a sluggish performance I realised 2 out of 3 of the belts had perished on my Wadkin AGS, I bought what I thought were the correct replacements (22.5” v belts from bearing boys) but on trying to fit there’s no way the motor plate is aligning with the 4 bolt holes as the...

Hi mark, could I grab the sorby roughing gouge if still available, I’ll send you a DM

Wanted single phase spindle moulder for small joinery/furniture workshop. Based down in Kent but happy to travel for the right piece of kit. Ideally with power feed included but not essential. Many thanks

Afternoon Alan I’d be happy to purchase this if it hasn’t already been purchased. I’ll you a pm

Thanks Paul, I’ll send you a PM

good evening all I'm after a couple of jigs for a Tormek. The TT-50 for lapping the stone and the SE-77 square edge jig. if anyone has either or both that you'd like to move along please get in touch

Ill take this if still available

Hi Jacob, Ill happily take this if it hasn’t sold already

Evening Steve If the collet extensions haven’t already sold I would be very keen to purchase. All the best

@Zeddedhed I came across this feed while looking into the Hammer A3 31, I’ve only just joined the forum so cannot direct message you but was hoping to enquire about the A3 26 and if you were planning on selling. All the best. Ezra