Search results

i Had a Good look underneath and all seemed well the Pivot slider was ok didn't appear to bent in any way , i started from scratch and realigned the blade but still the problem exist , what i have noticed is at the extremes of the blade ie the highest point and the lowest point is where it is...

Thanks ETV i will have a good look at this this weekend as its a long one so it gives me more time not to rush things Thanks for your advice , i will report back

Bristol its only round the Corner Ha i appreciate all your help , Pivot Mounts i assume are the four bolts 2 at the front and two at the rear that align the Blade not sure what the pivot sloder is ? its quite difficult to find the center as it doesn't exactly swing freely to be honest...

Thanks Eric the first time i aligned the blade to the slot i set it to far over so when i tilted to 45 the blade touched the table top so much that it wouldn't even go to 45 as the pressure of the blade on the top stopped it so i adjusted it and move it towards the fence slightly, tightened...

Thanks JB to be honest it seemed to work fine , it only developed a problem after i started to try and get better results by calibrating it so i doubt it would be twisted as its never taken any hits or bangs , just weird how the back of the blade pulls towards the slot when lowering , it has to...

Thanks for your response & the welcome mine would only ever be in line or parallel at the point where i calibrated it to the slot , any up or down would move it from that point so its only ever good at the point where i align it whatever height i set that at from the start

Hello All i am currently trying to fix my Axminster Ts200 table saw , the problem i have is when im trying to calibrate the saw i can align the blade to left hand track (Slot) but whenever i higher or lower the blade from its current position the back of the blade moves towards the track the...