Search results

Tempted by the Bahco now, about £9 for one and I could get it tomorrow. Otherwise the Veritas ones will wait for the next Axminster order. After much sanding it now looks like this. Quite pleased with it, but there are a few bits of white glue in the grain that will be near impossible to sand...

Thanks Doug, that's useful to know. I'll look to add some to the glue collection. Titebond's PU glue seems to need above 10 degrees though so any pointers on a low-temp brand would be welcomed.

Thanks tyreman. That is a good solution. I'm hoping that because the glue was at room temperature that it set up enough inside the joint. I don't have card scrapers yet, and they probably would have helped, it took about an hour of sanding with a ROS to get that dried glue off! I was in a...

Thanks Ttrees. Working in the garage for the last few evenings has convinced me I should invest in even some simple heating for me and the glue. Is there a brand of oil rad that is good to look for?

Great idea, thanks grumpycorn! Would you wrap the job in the blanket or just lay it on the top of the blanket?

Not the last thing I've made, rather the first thing I made that is in active service in the house instead of the workshop; a small hack of an Ikea shoe cupboard where the shelf is too narrow to be of any use. The plan was to put a front on the drawer but I don't really want to cover it up :)...

Hi Adam, I tentatively tried to flex the panel at the centre to see if it had any strength at all and it seemed solid. I then supported the two long edges and placed a 10kg kettle bell on the joint and it didn't fail but I only left it there for a few minutes. I'm not expecting it to get any...

Thanks TheTiddles. I was hoping the same, that it was just those messy smears that were affected. This is the first project I've done at this time of year and I didn't even think about the cold affecting the drying process until I saw this :( I think I will have to start doing the glue ups...

Hello. I am still relatively new to woodworking and learning a lot on each project and from this forum. For my third project I have started building a play kitchen for my kids for Christmas. I glued up this panel for the worktop from two oak boards (800mm x 210mm) in my garage workshop on...

Fingers crossed this was just the first instalment of the delayed stocks!

It was because of this thread I knew it was available, so thank you for the heads up. I just never got around to actually ordering and now regret it! I didn't realise it would sell out quite so quickly.

Sold out :(. Do things like this come back into stock normally?

They are on offer again on Amazon, and currently in stock, £203.99.

Where did you find it for that price, or was that Amazon still? The next cheapest now in stock is £254 at CPC.

I had this in my basket today but it went out of stock before I pulled the trigger 😭. I think this might be my first post?! Hi!