Search results

That’s lovely piece. What would that cost if you don’t mind me asking.

Re the woodworm, put in the freezer for a couple of weeks and you should be fine. As previously said, the Beatles are most likely long gone :)

I never wear gloves after a close run many years ago. Yes I get plenty of splinters and cuts but have all my digits (having spent 4 hours in a&e today after slipping with a chisel!) I think it can all be reduced down to: Be careful when using tools, don’t put your hand anywhere you shouldn’t...

Have you a photo?

May be worth contacting your local wood recycling project, ours in Southampton has a lovely workshop where they turn out some nice bits of woodwork...

+1 for a router, a secondhand dewalt with interchangeable bases can be had for sub 200. An additional base turns it into a router table too :)

Thanks Pete, will give that a shot :)

Hi All, I recently purchased a used Dewalt BW682 Biscuit Jointer and have found the handle on the top is worn and wobbly. I have experienced this problem in the identical tool it is replacing. The issue results from the anti-rotation male and female square parts are just not deep enough, so...

Thoughts on this as a budget option? https://www.amazon.co.uk/Energy-Powerdo ... B00VKU57D4

My friend runs one in his van full time, says it runs smoother on kerosene

I’ve been quite ‘relaxed’ with my application technique using anything from offcuts of 3way stretch carpet (for lining campervans), brushes, slopping it around with a finger or an off cut of a rag. I’ve found it to be quite forgiving, but have unsurprisingly noted pigment being left in areas...

Thanks for the advise, been looking on Axminster and they have a huge range :)

I’m sure this must have been covered but can’t find any previous posts... Looking to source replacement blades for my Irwin pull saw but can’t find any online. Alternatively I’m happy to move to a different brand if ther works better long term. Thanks in advance

You could try totton timbers near Southampton...

Love how the table top has a smiley face in it :)

Would it be possible to have the holes drilled vertical and a much larger counterbored hole at the bottom, that way it could be made to a much sloppier tolerance.

Really enjoying your WIP, need to find some time to get my shop organised. These could look cool on the screw storage bins... https://rover.ebay.com/rover/0/0/0?mpre ... 3041419709

It looks laser cut to me.