Search results

I’m with M&S for the same reason. NFU will also insure an outbuilding and contents for a specified value but they were somewhat more expensive. Richard

My collector is mounted to the stand and not the saw, it’s a tight press fit to the saw body. I placed a couple of blocks on the diagonal and at the back to support it. I’ll take some more photos but it won’t be until later this week. The crown guard wasn’t successful and I would buy a new...

The riving knife is only mild steel so bends easily. First check the thick shims are flat, mine had a slight lump when they’d been pressed out. Once they’re flat shim up so the bottom is aligned with the blade and then bend the top over to align with the blade. If you knock the crown guard it’s...

It’s a good solid saw but Axminster could so easily turn it into a great saw with a bit more attention to quality control and a few mods. The fact that the extension table is wider than the main table is not really acceptable, the fact that the left mitre slot is slightly wider than right is...

Hi Mike, It’s the only bit I’m not happy with. There is very little airflow through the smaller pipe so I’m going to try connecting it directly to my Henry to see if increased airflow helps but I suspect I need a bigger pipe and a better guard similar to yours. Richard

I've found this post incredibly useful and have implemented many of the changes myself so as my first post on ukworkshop I thought I would share my variations in case they help someone else. The stand is made from 4x2. I made my own dust collector underneath the saw and re-used the included...