Search results

Morning all, wasn't really sure who to ask about this so thought I would try on here. I have some rattan garden furniture with adjustable feet, the bolt has seized and not the threaded insert is just spinning and I cant get the bolts out, any help or recommendations of how to remove and repair...

Because I want to scribe the bottom batten to the tiles and leave enough gap below to allow water run off.

Unfortunately not as it's for batten cladding on a wall and I have a 2x1 vertical batten every 400mm and horizontal lengths attached to it.

I agree that it's ambitious lol, have already made a cut with the tracksaw which was supported with material of the same width but I just wish I had a better way. Unfortunately I think this is probably the only way to do it in a safe way. Cheers

Dont have a thicknesser unfortunately

35mm down to 10 mm

Thanks for all of the replies, looks like which ever way I choose it will be a bit of a bugger lol. Do you think this sort of thing might help on the table saw? https://www.axminstertools.com/trade/axminster-taper-cutting-jig-310078

Evening all, I have a few tapered cuts to make on material that is only 50mm wide but is 3m long. Can anyone suggest a way to do this safely and accurately please? I have tried with my track saw with rails connected together and material supporting it so it wont tip but just seemed like...

Not really and it's probably not worth worrying about but I have never owned a cast top table saw and want to keep on top of things if I have to.

Thanks everyone, they sent a replacement top out but it was worse than the original. In the end I have told them I will just keep the original and repair it, they will also give me some cash back so im happy with that. Anyway with the chip on the cast top, what would you use to repair it...

Evening all, I purchased a Axminster AW254TS (bench) table saw. While I am quite happy with it compared to my old Dewalt, much quieter and I like the cast iron top. I am not sure if I am being too fussy when it comes to the actual cast top. When it arrived it had a couple of small chips out...

Morning all, I am collecting a second hand Tormek T4 today and have a couple of questions for anyone that uses them. It comes with the original Aluminium Oxide stone but looks like its not been used a a while and is brown, is this easy to clean up or does it not really matter? It does not...

Which did you go with?

Can anyone give any thoughts on these 3 bench grinders please, I did not want to purchase the typical cheaply made from Axminster or Record and came across these Warco models. Thanks Mark https://www.grinders-shop.com/heavy-duty-bench-grinder-8/...

Sorry now sold

Thank you for the help, much appreciated.

Can I ask how you would recommend grinding a flat edge on the bit for the morticer? You might be able to see it in the picture. I was sort of thinking a grinder might just be a good little addition to the workshop for some tasks. Thanks

Thanks Phil, I dont have a lathe. I suppose like many I dont particularly like sharpening chisels, so I thought is I had one 120g CBN it would get a decent edge and then finish of on my flat plate.

Good morning, I am looking to purchase a bench grinder and need a little guidance choosing one. I have been looking at the Record Power and would mainly be using it for starting my chisel sharpening before hand sharpening, I also bought a Multico morticer and purchased some mortice bits...