Search results

its not always how many watts the tool is, its the hammer that knocks it in that counts most

they can go get a warrant

never seen coments about jeffries glue or is it only sold in large quantities

heimlaga is not quite correct to say second hand ac stick welders are useless, if you can find one with open circuit voltage of 80v or 100v they are ok

finally got round to taking the sliding table off, the adjusting set screws are the cheap nasty rolled on thread type with concave ends, so whoever has put a number of circular indentations into the load spreading pads underneath the table, so when you try to adjust it, goes all over the place...

thanks for everyones efforts recon i,ll have to seperate the top from the bottom and check it out will post something when i get a result

t hanks for the quick reply however it,s the sliding table.when it,s at mid point it,s fairly compatible with the saw table, when pulled back fully from the saw blade the forward end of the aluminium table rises 2mm above the cast iron saw table. i can,t find any slop in sliding table bearings...

hi,can anyone guide me to a website that details the setting up of the robland nlx 310 tables, i have bought a second hand one that is all over the place, any help would be greatly appreciated