Search results

Sounds like it’s been dropped from a great height… I’d keep looking on EBay for a good one, they can be found quite cheap..

Second Hand Tormek???

Have a look on Aliexpress…they have individual collets and sets..

I’m looking for instructions or any information on the Jabus Ball turning tool, and the Jabus Optiset, centre finder, from Jabus Engineering Ltd Devon….They are no longer trading… I have one of each tool but very little information on them Cheers

Get yourself a CBN wheel…you won’t regret it

I’d go for a 10” T7or T8…obviously more expensive but more powerful motor.. I’ve just bought a second hand T8, like new with hand tool set for £600…only used a couple of times… They are usually between £500-600 second hand for what I’ve just bought…new price is £900 If you’re in no rush just...

Exactly…keeep it simple

Thanks….luckily I’m in no rush

As above, you just have to keep looking as not all sellers use the same definition… I buy a lot on EBay…you need to state fully threaded when you search.

Thanks…I’ve contacted the seller Sold 5 minutes ago…🙁

Would stainless be a better option?

I try to keep it simple…

Oak breadboards make great jaws…

Wrap some fine sandpaper round a piece of dowel and open up the hole until the dog is a tight fit

Use a drill press with a vice that has a vertical V in the jaws, clamped in position on the table so the operation can be repeated..

Loads on EBay…with size options.various lengths diameters and wire diameter…usually from China….make take a while, but very cheap Cannot you find one on something else like you’ve suggested…a ball point pen and cut to length

Wanted Tormek T8 in good condition JohnHall….Manchester 07808243789 [email protected]

Condensation caused by the cold temperatures ..it’ll be ok in summer…try a dehumidifier

Not at all…I’ve used one for years with absolutely no problems

Not at all…taps are made of carbon and high speed steel…I have a 6” dia wire brush permanently fitted to my bench grinder that I constantly use for rust removal on old tools etc…I’ve cleaned numerous taps with absolutely no problems regarding dulling the cutting edge For small taps i use a...