Search results

I used to use Talcum Powder in cellulose dope to act as a sanding sealer on my model aircraft, they always smelt so nice. 😜

Stain the skirting/architrave and use brass screws and cup washers, various size's available.

+1

Normal permanent repair is to attach expanded metal over the crack and plaster on that.

Fishing wader boot studs screw in, lots of different types, styles and materials.

There is an example of this on a factory/office you can see whilst driving towards Maidstone on the M25, its an open structure with helical blades, I have no more information on this, its just an observation.

Watched it right up to the point of not having a crown guard on the table saw on a full depth cut.

Meanwhile the Electricity producers are sitting back and laughing at all of us, while the Governments push us more and more to using electricity, our infrastructure is old and will not be able to cope without massive investment, so I suppose it's self sustaining.

I also use a piece of plate glass without the piece of copy paper, set up perfectly every time and never had any snipe, IMO if you set the blade higher than the outfeed table you can't avoid snipe.

Merry Christmas to all no matter your colour or gender. 😇

Izal also made a good Gazoo on a comb. Even our toilet at home was in the garden.

I just wish I could teach my wife to close the back door, heating on, back door open when she goes to the bins, appalling waste of energy, I don't do bins too busy building stuff.

The hammer action on my Titan has packed in, obviously just when I needed it.

Just my 2p worth, lot of talk of drill press quill run out, most will fully extend the quill and then measure the run out, IMO that's not the way to use a drill press, take the table up to the non extended quill and drill bit, minimum quill run out and an accurate hole.

Never let me go, wasn't that a song by David Essex? Ah ha it was "Hold me close" "Don't let me go"

Or you could take an old lamp and turn it into a wooden smoothing plane, or with the advance's in LiFe batteries and out-runner motors turn it into a model flying plane. 🤔

Never let the truth get in the way of a good story. (attributed to Mark Twain)

🤣

Not unfair at all, solenoid's do not get weak, they either work or don't, do let us know when you have drained all the condensation water out of the tank it it starts working properly, of if you replace the Riello burner, I tried to be helpful, but I suggested three times to check the water...

There's an echo in here. 😇