Search results

How will shortening the morse taper help? The black mar near the chuck will not change! Leave it be. Look at smaller chucks and tapers.

Looks like Nutool, circa mid 80s

Awaiting delivery of a dedicated psu, fan cooled with variable 2v voltage increase, so I just hope that solves the issue. If not, then the 12v regulator may be the solution. thanks to all

Update Voltage readings at camera. 18mtr factory terminated lead - daytime reading 11.68v. Night time reading with leds on 10.49v- 1amp.

plastic will sweat. Source those moisture absorbing crystals.

Of all the morticers I used over my working life it was the single wheel dual action I hated. keep to the twin wheel, back and forward on smaller wheel, side movement on the bigger.

I always use oil paint. Only one primer for me, Dulux aliminium wood primer.

Caution, consider the final job as what goes on the table gets transfered to the planed surface and will impact on any paint, varnish or stain.

I take it the lock is the original mortice style and not rim. Always an issue with the mortice lock as it took out the tenon at that joint. Done many of these over the years and aided by the loosening of the joints, from dipping, I just knocked the appart. Once appart I cleaned the joints and...

top tip

top tip.

The practice of grinding one's own cutters will continue. Big tool room at the college I learnt my trade, 1980, and although they had a profile grinder many were ground by hand. The use of the old whitehill style blocks will also continue as the demand for the odd metre of matching skirting...

thanks.

Too easily toppled those bottles and gone un-noticed the oil will, from my experience, leak out. As mentioned above old school oil can. Metal, 200ml with flexi spout.

Will a loop tester thingy be needed for that?

The furthest camera is 12mtrs from hd. All eight cameras are wired using the factory included 18mtr leads.

thanks for input, just wondering, is there a safe percentage increase to the 12v? Looking at a cctv switching psu's that has a potentiometer to increase.

to be honest I thought they were all 12v! Eight camera kit, swann, and as I said pleased with the quality and their support both online and phone.(influential in my purchasing)

I am going to dig out my multimeter to establish dc at camera end! Cables now unwound. Cut outs tend to be at night so I guess the infra red has more of an impact on the draw than the camera. Motion sensor mode also switched off. Amps, of what?

Is there a finish on the wood? I would try brown paper, manila envelope, and warm iron. Hold paper in place over wax stain and apply the iron, to paper only. The paper should draw the wax into the paper from the heat. Not too long though and not too hot!