Search results

Agree, if a plane then from experience unique threads. Cast, usually coarse and usually imperial. UNF and UNC american

fingers crossed

is the blade clamp out?

Is there a tech college near your? Done an engineering course at mine and they had spark erroder, removing the broken taps appeared a daily job for the store room technician. . My local pattern maker also had one. Again, if one near but again its a cost. One home made penetrating solution, as...

Welding nuts on, milling out, or spark erroding you will be putting your hand in your pocket, if you can find anyone local and prepared to spare the time. Seen two of these broken in half at hole, in my career. For me its a no brainer, new part. Plenty of used pts on facebook market place.

All sold off, private ownership, greed and no accountability, who would vote for that?

you could try ams machinery or daltons as they may sell new bolts.

CNC machined all that and as offered in singles, not paired, their confidence demonstrated.

The joys of buying used! I personally would, from looking at the work involved and mess of bolt heads, bite the bullet and get the kit from the main dealer. Two or three knife block and is the price for all? The machined relief at the underside of head is there for a reason as too the square...

Struggling to understand how any of the bolts have stripped as they would be loose, not exerting pressure onto blade. Wedge looks caked with resin so perhaps that has seeped into threads gumming the bolt causing the shear. I had my own joinery shop, 16 and 12 inch dominon p/t's and 24 inch stand...

The wedge should come out, when all bolts backed off. The bolts back out with the head exerting pressure on the blade to hold firm. Once out I would persevere in trying to get the broken bolt out. Heat up with blow torch, penetrating fluid or dill hole and use an easi out. I certainly would not...

what were you looking at, photovoltaic systems and solar? The beeb had an article on a show two weeks ago where the home owner recently installed a system where the surplus power was stored. He bought two or three special batteries and claimed that supplied the electric to feed the house through...

When is the mot due? Non working dash bulbs just may fall under that,

could be a ref to where found in manufacturers workshop book for car, wiring loom ref, plug ref etc. still not working then? Honda may have a diagnostic service. Most are compreshensive and pinpoint the issue, the last I saw indicated the motor in the heater unit of a vwt6 within seconds. Costly...

are they traditional bulbs or led?

Just found this on youtube, 2005 honda crv, .

Just wondering if there is a master bulb, like the old xmas tree lights, one goes they all stop! If cluster out check printed circuit card and try to establish feed and neutral as that just may track through one bulb first then out around to ohers.

I had the same problem and I did use an expoxy resin. Perfect, sealed the floor and twenty years on as good as day it was poured. Swept away all the loose stuff and followed instructions on tin. Unsure of the brand but the kit was simple, pull the plug on small tin and let that flow into the...

Where did you get the replacement bulbs? Had an issue years ago where the only bulb that would work was the one purchased from main dealer. Apparently something to do the monitoring system and resistance. Some dash bulbs are 14volt too.

CONVERT. oil based cuprinol was the only product for me on my outbuildings. NOW I use the water based ducks back. Brush on, the first coat is tough going, both sides of 16 standard 1.8 panels, but the second and third coats, as per instructions, a breeze. Great protection, water runs off, and...