Spectric's latest activity

If doing this then use a 6mm dowel, but would it not be just as easy to take the parts to the destination and then assemble ?

Just an excuse, the real reason is that with doors you just tidy up and throw everything into a cupboard and shut the door, instant...

The best way to ensure table saw safety is to keep a certain sector of people well away from any machinery, these are the ones who need...

Put a fan heater nearby to dry everything out .

They seem to cut worse after I sharpen them, the best I have had is with the scary sharp .

These days following an upgrade you want to do a clean install of your actual programs so that it loads all the latest drivers and...

I agree that I am old school and I also find some of the modern concepts rather difficult to take onboard. I put a lot of this down to...

Can you not buy the original brushes as a set ? With high current devices they do use a percentage of copper in the brushes, common...

If it is an RCD that is tripping then that could be an insulation issue as those devices work on an inbalance between lines. At any...

More info, single or three phase ? Have you inspected the cable, it sounds like a sudden change from working to this and a damaged...

I think the major influence here is the material being cut and using the right blade. I think of the rubber strip as a zero clearance...

Yes I have the Trend version, well an early model but it failed to perform so went to the so called Scary Sharp system which also has...

That G sharp looks similar to a Trend version https://www.trend-uk.com/ftsmk2