You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support UKworkshop.co.uk:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
S
Well, there is a clear concensus in this thread. Snails / zero flute seem to be the way to go.
I mentioned that I have a number of 3...
-
S
I use the Fisch countersink bits with the single hole through the middle. Stays sharp and always makes a clean hole. They do two sizes...
-
S
Thanks for these gents. I do have a large version of this (with the hole) that I used for metalwork until I blunted it on stainless. A...
-
-
S
Make a jig for the bandsaw, you could have 4 holes with stops so each time you get four components, it is how I cut dowel rod down...