J-G's latest activity

I'm sure you can understand what shape a 'V' tool is, but the difference between A 'U' and a Parabolic could well be more difficult to...

Ah. - appologies, I should have said that it is Windows only - I don't have the nouse to write for the dark side :)

Imperative reading for anyone who has any interest in gear-cutting. @Chris152 You may be interested in looking at a program I wrote a...

I agree Ian, but as the desk top is supported by the two pedestals with something like 600mm between them, the chance of 'flexing' is...

That looks eminently doable, the only thing that could go wrong is if the panel is large enough to flex, but that’s easily fixed. Ian

NO 'E' !!!!!

I've had further thoughts on this matter and suggest that if (when?) you do go down this route, rather than use a butt joint, (with...

You appear to be approaching this subject from an academic viewpoint - rather than a 'need to make' one. Gear Cutters for use with a...

They are close to 29/32 & 25/32 but those are undersize in all cases.

I agree that 30 or 60 plates are unlikely to be available, I was trying (and apparently succeeding) to give the OP the basic principle...

Dividing heads are not just used to make gears. They can be used to create 'flats' at specific angles to each other, specifically...

Google "DIY folding saw horse" quite a few videos and instructions pop up. p.s. Given other words in the sentence, that is a world...

Firstly - [10" diametral pitch] doesn't make sense. You may of course mean that the Pitch Diameter is 10" - - - if that IS the case...

Simply Bearing list them at £2.51 (from memory!)

Not specifically for Skate Board wheels - that's a standard code 608 with whatever pre or post anotation to indicate type of shielding...