J-G's latest activity

Simply Plastics do a cut to size service - Clear Acrylic 4mm thick at 291 x 884 would be £17.63 each. They also do a 'Glass Look' which...

So why did you specify 900 x 600 ??

Hmmmm.... I hadn't come across Sheetplastics, I usually use Direct Plastic or Simply Plastics but as an exercise I have looked at their...

If you can't find a copy of SketchUP 2014 - the last that was completely free - on line, I could make a version available - PM me. I...

Arris rail is a 45 degree right angle triangle. Join it to a square post and the resultant angle is 135 degrees. While it is true that...

With regard to the chicken and egg situation this is perhaps where government needs to step in and give things a nudge. Spain for...

I could have been more specific. The size that a Jobber Twist drill actually cuts is dependant upon many factors. Even though you used...

?? - if you want holes 'to size' drill smaller and finish with a Reamer - - - Simples!

Not only copper, I know someone who had solid marble counter tops in the kitchen. They soon learned not to cut lemons on that as well.

Would it not be more economic just to buy a stick of brass bar of the correct diameter and make the nuts from that? It is a lot easier...

Not a 'Bad' Phil - - - it's down to nomenclature. (Again, I've said this before) the term 'Quench' can (is?) often...

5mm is 0.006" larger than a #10 so shouldn't cause much of a problem. 0.8mm pitch (the M5 standard) is 31.75 tpi and #10UNF would be 32...

I've said this before Phil - - - HSS should always be quenched - - - BUT it should never be allowed to take on even a light-straw...

Hmmmm. . . I had an F22 error code a little while back and after two 'Professional' plumbers advised that I simply needed to replace...

That's a moot point - and certainly why it took many 're-writes' before the 1297 version came into effect - and has ultimately been...