fleyh's latest activity

Wise choice :) Thank you. If you could write a review with pictures after you've had a chance to familiarise yourself with this plane...

If the force applied is a peel type, then any rare earth (neodymium) magnets could work, as long as they are rated for the weight you...

Commenting to bump your thread and also, selfishly, to ask a question. :) I’m not a potential buyer at this point in time, but I’ve...

The 2 index pins will close down enough for a sawblade as long as its flat topped.so narrow fingers are fine But I can't see how the jig...

I Googled your narrow blade question and came back wit. Yes, the Incra iBox can be used with a cutter that is narrower than the joint...

No it's a dado/router jig and doesn't allow any method beyond a simple single width pass through.(I think!) But with the correct...

Thought I'd give this an unbiased review. I brought it brand new secondhand with no box. It's a jig with a single purpose... finger...

Thank you for the review @johnnyb Can this Incra jig be used to cut box joints on a table saw without dado support? i.e. can it be...

Have you considered Bobbin sanders (Spindle Sanders) or simply using drill attachments of various diameters to sand inside the corners...

I kept all my 2.2mm Festool blades when I upgraded to the Mafell. Kept my Festool tracks too. All work fine together. As @Spectric says...

Depends on the operator. If the OP has the same talents as I do, then Mafell won’t stop us. Standard Mafell blade is not particularly...

Have you found any that are multi-use? The last time I looked into this, all the commercially available options I found were single-use.

Hello @NewbieRaf This may not be what you want to hear, but if you value your health, I recommend listening to or watching this: It...

A 3D printer is like a microwave oven (from many years ago). Once you have one, you ask yourself, how did I get along without one for...

The likely reason is that they did not want to impact the sales of Mafell KSS saws.