deema's latest activity

One of the top sashes had some slight rot on the bottom rail outter edge and as it was not too deep I did not want to take the sash...

Not wanting to be offensive or anything, but all this talk of machining shafts and work holding in the lathe is completely pointless if...

Yep, no worries I will photo when I pop into the workshop. The shaft is fairly short so no steady required. The end has a taper and then...

The spindle is removable. Inside the cabinet under the pulley there is a long screw, you undo this a few turns, give it a tap with a...

But China is not a western economy, they cannot just ask for a payrise or threaten to go on strike and does China not keep it's...

I see that because people are living healthier and are getting taller ladder manufacturers are increasing the spacing between the rungs...

Wheele bin, bin people never touch the contents, and you put broken glass in your waste bin?

Just toss them in the recycling bin along with all the other sharp edged tin cans. Geez some people really over think stuff……or does...

Hello, I am new to this site, and wanted to join because I intend to make some small object d'art and practical pieces from the big...

Use the walls, but keep your stuff in boxes to protect from the damp. French cleats and wall boxes Ally profile extrusion makes a...

Marking out the stiles was done sraight from a rod (a lot simpler than marking out the curved top and bottom rails). I first mark one...

I was lucky at the time when I got the job because I already had a tenon machine so could use it with cradle pieses to machine the...

This is what the top of the spindle should look like. There should be two flats for a spanner.

Transfaring the marks from the setting out rod required me to make a lot of jigs to hold the sections in the correct place for marking.

The SM4 spindle doesn’t lock, you use two spanner’s, one on the top of the spindle and the other on the nut.