mark w

I have a set of the Lie Nielsen chisels, a set of Sorby chisels and a couple of Ashley Isles chisels, all very good, for price to...

Another thing to check is the thickness of the blade, occasionally some blades are thicker on one side, for example the left corner...

Nice work, welcome to the forum.

I've got one of these, very accurate for a tape measure...

If tasked with this window I would do the following. Copy it`s design and mouldings and make it traditionally, adjusting slightly for...

Thank you very much for the response, I started off as a self employed tiler and learned everything else on the go. I ended up doing...

Thank you very much! I’ve done the staircase from scratch because my brother wanted deeper steps…….I’ve jointed the stringers from 2...

Hi everyone, my names Jamie, I’m from south wales. To cut a long story short, i used to be a very successful tradesman 3 years ago until...

Well yes and they are nearly always into thin stuff; drawers or carcasses etc Just a very useful joint well worth getting on top of...

Actually, if comparing them to some other joints, for example a hand cut mortise and tenon, dovetails are quite quick to cut. That's my...

Dovetails are good strong joints, why avoid them, is there a better joint to be used between drawer sides and their corresponding fronts...

Jacob, fine and freehand in a dovetail joint isn't an incompatibility as far as I know. I give you the example below which I reckon fall...

I know I know, I was just being facetious. But what can you learn in a day and is it worth it? Would a one day course in "traditional"...

Her name is Daisy Brunsdon

She gave a talk at The New Makers Conference last year, unfortunately most of her time should have been taken up with a PowerPoint...