UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
R

Rob D

Established Member From Wotton Under Edge
Joined
Last seen
Messages
31
Reaction score
1

Latest activity Postings About

    • R
      Rob D reacted to meccarroll's post in the thread A Kitchen for daughter with Like Like.
      This was a project this year, cabinets made of MRMDF, carcases Melamine faced chipboard and spray finished in Renner water based paint...
    • R
      Rob D reacted to AES's post in the thread Missing with Like Like.
      Just a quick one from me to say a real thanks to ALL of you above for your comments and responses to "my" post (actually Morris...
    • R
      Rob D reacted to Blackswanwood's post in the thread Wood id quiz with Like Like.
      It looks like you are the only entrant @Fitzroy ! You were actually spot on with the two you named. They are: Top lhs - Elm, rhs -...
    • R
      Rob D reacted to HOJ's post in the thread Next up: Oak doors with Like Like.
      Quick update-: Glued up door as a single unit, I find it makes it easier to keep things square: Door split in two and meeting joint...
    • R
      Rob D reacted to HOJ's post in the thread Next up: Oak doors with Like Like.
      And for my next project, I will be converting this lot: Into something like this: And along with that, I am converting this lot...
    • R
      Rob D reacted to AJB Temple's post in the thread Wood for fitted bookshelves with Like Like.
      I have done exactly this across half the room width at both ends of a quite large room. 3m span between brick piers at each end. This...
    • R
      Rob D reacted to Wilson joinery's post in the thread Wood for fitted bookshelves with Like Like.
      mdf is cheaper and paints better. If you use a good mdf primer and topcoat using a foam roller you can get a really nice finish...
    • R
      Rob D reacted to Derek Cohen (Perth Oz)'s post in the thread Trim router table for MFT with Like Like.
      It's not as if I do not have a router table. I built a very nice, full featured one, four years ago, into the outfeed of a Hammer K3...
    Show older items
  • Loading…
  • Loading…
Back
Top