SkinnyB

I made one using a Triton Wide Planer some time ago. Much quicker/better results. Harder to make though. Video: Build thread: (Final...

I bought a small dial indicator, bit of 3D printing and some laser cutting to get the twin drums on my sander perfect. Ive tried feeler...

Here are some of my end grain boards. Sussex based, made to order and in-stock boards available. Laser engraving options...

Simplest approach would be get a decent sized bit of 2” thick sycamore or beech, plane it flat and you’ll have a nice board that will be...

As the ebonising isn't very deep you are correct in that it can wear away. Being that it has an oil based finish (Osmo top oil) it would...

As promised some photos. The grub screw is a little long but I tend to use what I have on hand. You don't need to adjust it every time...

I like my ebonising and use it a lot for my furniture and boards. Fine wire wool soaked in cheap white vinegar from Lidl. I usually...

Best way I found to fix these is to tap for a grub screw on the back of the part that slides up and down. Try to get the grub screw near...