meccarroll

This is an old thread (10 years plus) if you post up your location someone on here could then contact you. Sorry just checked and...

Just a few ideas: If I was doing it I would shape it on my spindle moulder out of the solid but you may not have that equipment. If I...

If anyone saw the shake in a shop they would not buy the table and I think anyone seeing it as part of an inspection process would see...

I imported a CNC frame from China costing about £500 the import charges ended up being around £100. I got a letter stating I had to pay...

T2 has less additives so more reliable than T3 (both should work if used as per instructions). T3 should be ok but you may need to take...

It was just one I found on Facebook Marketplace. Not sure if it would be much of an upgrade on the one you have now apart from the tool...

https://www.stepcraft-systems.com/en/start

Is this of any interest it is currently on facebook market place...

Yes it does look complicated, I also took a look at this video which, I think, helps clarify how to set up each tool to start with:

Took a look at the video and think it would be too much for me to tackle right now. I did like the tool holder he used which seemed to...

Very good point about dust and air blowing before a tool change, I have read it can cause problems if you need precision. I'll take a...

I have seen this system before, the only thing I think might be a problem is if it becomes slightly out of line and strips the thread on...

I have sprayed Cellulose many times before mainly in the open, it's quite easy to spray in some respects. It is a volitile paint based...

I would consider moving over from your noisy HVLP Qtech 5 to a compressor with a HVLP Spray gun because the noise difference is huge. I...

I'd love my srurdy metal framed CNC Router setup but it's manual change and mechanical hold down only an ATC CNC with vacuum would be a...