Inspector

I have a couple of these...

I have a 2.6m one I keep in the RV trailer (caravan) so I can get up high enough to sweep the top of the bump-out off of leaves before...

Have you ruled out the water feeds to the shower? It is possible when the water is turned on some leaking occurs after the valve on the...

Try directing a shop vac nozzle where the off cuts are. It should suck them up as they are cut. Doing bundles like Chai Latte suggested...

A Google search yields his website: https://seanhellman.com/product/shaving-horses-lap-shaves-and-other-woodland-vices/

Where would one get a copy of your book? Pete

Obviously can't help from here but have you got a circular saw or able to rent one and make the cut freehand following a line? Pete

I wear anti-vibration gloves (Impacto Air Gloves) when using tools that vibrate or my fingers tingle and go numb. Routers, all hand held...

I have a 3.5kg tin of Johnson's Traffic paste wax. It's donkey years old but still does the job. It's great on lathe bars, bench saws...

The 44 Magnum most common but there is a 45 Magnum too. https://en.wikipedia.org/wiki/.45_Winchester_Magnum Pete

Well I have decided I need to take the weight off the old legs more often working at the bench. I do have an old office chair in the...

I envy you as I do with about the ten or so in our turning club that have them. Someday. Pete

The designations here are nominal, not absolute. I took a walk around the shop and the different motor data plates are marked with 208V...

Welcome to the forum. If you only need a small amount you can make your own with a few standard router bits in the router table and the...

Be aware that thicknesses and planers don't just make chips/shavings. They also produce a lot of fine dust. I showed it in this thread a...