Ollie78

Shinwa fit gear kiwadashi, is my new favourite. Printed both sides metric only, good quality, easy to read, nice hook. No magnet which I...

I have a light with a microwave sensor in the workshop loo, works through the wall surprisingly. Might be able to get a sensor on its...

Hi, Nick - I might be interested - someone has kindly suggested me in another reply ... Let me know dates, terms etc ... Andrew...

No issue with Birch specifically, it is a nice wood. Perhaps birch ply would be good for reasons of stability and ease of machining big...

I would probably get it out of 65mm thick timber with the stiles and top rail 125mm, mid rail 175-200 and bottom rail 200-225. @HOJ...

Yes, full tenons on the rails and stiles. On the diagonal braces I think I did one large domino on each end, just to keep it flat during...

I was going to say the same as @johnnyb about the braces. Here is a door I did as example. You just make a little mdf jig to router...

The braces as you have them are pushing outwards and put more strain on the M&T joints, Quick Look online found this arrangement...

That could be an expensive day !!

Can`t help with exibiting but I think I will visit the show, almost went last year but couldn`t get there. I do wonder if you should...

You could do this on a cnc but as said above it won`t stay that accurate because its wood. Looking at it I would be inclined to use the...

Pretty much all tvs will have a 60hz refresh rate, some may have more and pc monitors often have way more like 165hz etc. 60 hz is fine...

I must disagree about the sound quality, most of the tvs are so skinny now there is only room for crappy speakers which despite modern...

Ah, don`t know anyone in Somerset for units I know there was a good one in Bristol but can`t remember the name of them. I usually...

Another factor is what "operating system" it runs. I can only fit a 43 inch tv in the place where our tv lives and have been looking at...