Articles

Post thread
UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Importing Power Tools from the US

Before I start I must mention that I am not a qualified electrician so therefore we can’t take any responsibility – the information below is just purely my experience of importing a power tool from the US!…. I’m quite fortunate that my sister has a US postal address and the other week when my mum was going to visit her seemed to be a good time to order a few bits from over the pond. I had a rough idea what I wanted and visited the WoodCraft, Rockler and Amazon websites to see what I could find. I ended up ordering a Porter Cable 690LRVS router. Okay, I do admit I have a slight router problem, whereas certain people have a plane for every day of the week I seem to collect routers instead! Saying that, I only have two routers which I...
View full article »

Cleaning Cast Iron Tables

A quick guide showing how to get your cast iron machine tables rust-free & looking like new… In my workshop, like many people I have a problem with rust and without regular care my lovely, shiny cast-iron tables turn a not so lovely rusty brown. My bandsaw table is quite an extreme case mainly as it’s been stuck in a corner and hasn’t had any use for a few months. But fear not, it isn’t as bad as it looks, with a bit of work it can once again look like new. There’s no magic involved – just plain old fashioned elbow-grease… The first step is to brush the table down and clear away any dust or chips. To get the rust off I use webrax. I normally either use the grey or brown sheets on my tools...
View full article »

Head to Head Mitre Gauge Reviews

This review was meant to be done a long time ago, but as usual my health has put paid to any plans I make, and so my apologies go out to Charley and Incra for the rather slow progress. The piece of junk that came with my saw Even though manufacturers have been making table saws since Noah built his ark (well maybe not that long) most of them still refuse to take notice of their customers and supply a decent mitre gauge with their product. The internet is full of disappointed buyers (myself included) who after opening up the box to their shiny new cast iron saw find a cheap bit of plastic stuck on top of a crude length of steel or aluminium, which is often a sloppy fit in the slot. I f these companies are incapable of producing a...
View full article »

Latest posts

Back
Top